Water Damage And Mold Restoration – What Is It? It is the process of repairing a house or property to its pre loss condition. Damage to the home could be due to an overflow, flood or any other water damage and mold event. The water damage restoration process involves several key procedures like loss assessment, categorization based on the water contamination levels, decontaminating and drying the structure, monitoring of the process and completion of the process. There are two large certifying bodies, namely the IICRC (Institute of Inspection, Cleaning and Restoration Certification) and also the RIA (Restoration Industry Association) that recommends standards for water damage and mold restoration. The S500 damage as a result of water guide is the benchmark tool that is used by companies that specialize in restoration of water damage.
Loss Assessment and Categorization – Loss evaluation is the first and the most crucial part of water damage and mold restoration. The assessment needs to be correct to ensure that the right response can be taken. In restorating the damage due to water, technicians and also the insurance firms must work together and know what is damaged and how to go about restoring the harm. Identifying the cause in the damage, documentation of damage, and accurate estimates are mandatory to get a proper water damage and mold restoration. Categorization relies on the contamination amounts of the water source. The categories are the following
Category 1 – This really is water from clean sources like pipes, sinks and toilets without faeces or urine.
Category 2 – This is water which has some contaminants like water coming from a dishwasher, washer or toilet with urine.
Category 3 – This really is water which is highly unsanitary and is capable of causing illness or death if ingested. Sewage water, water from toilet with faeces, standing water with microbial growth and floodwater are a few examples.
Decontamination and Drying – Right after the evaluation is done, the whole process of drying and decontaminating begins at the site. Based on the extent of damage, damage caused due to water can be classified into 4 types. Class 1 Damage- When loss is restricted to a small area and less water continues to be absorbed by materials. This results in slow evaporation rate. Class 2 Damage – When the damage would be to the whole room and carpet area. Class 3 Damage – When the entire area is saturated with water and Class 4 Damage – when there are lots of deep saturation pockets. Decontamination and drying is actually a key stage in Water damage restoration and equipments like blowers, dehumidifiers, scrubbers and subfloor drying equipments have to be used. Decontamination needs to be done if contamination continues to be detected in the area. Decontamination may be completed for the complete area or even in specific pockets where contamination continues to be detected.
Monitoring and Completion – Monitoring the restoration procedure for damage caused due to damage is critical to get the desired results. One must be proactive through the monitoring process. Checking if the drying tools are setup properly, assessing if the personnel involved are qualified to do the job and checking if the equipments are in working order inwtsy all area of the monitoring process. Necessary steps have to be taken if anything wrong is spotted through the monitoring process. The entire procedure of water damage and mold restoration will be considered complete just once humidity, temperature and also the moisture content is as per industry standards. Upon completion of the water damage restoration process, the drying equipment can be removed.